EVCT electric vehicle charger tester

Welcome to EVCT

EVCT makes a jig for testing electric vehicle chargers

EV cterger tester

J1772 type1

J1772 type1 connector include.

* 2.4inch PWM Wave display and analyzer include. (Duty,Volt)

* PP switch check indicator include.

* CP short,Diode short simulalte switch include.

* 12V/9V/6V/3V Mode select switch include.

Charging indicator include.

* Charging Load Outlte include. (MAX 220V /16A)

* Backup battery include for PWM Wave analyzer.

* Power On switch.

* Auto Power off function.

* 25x28x12cm Compact size.

Test method

Pre-Status: CP_SHORT: OFF / DIODE_SHORT: OFF / State Mode Switch 12A

1. Connect the charger handle to the charger connector.

2. Turn the charger into charging mode.

3. Change the state conversion switch of J1772 to 12A→9B mode: The screen of the charger should be changed to Charging Start/Charging.

4. Change the state conversion switch of J1772 to 9B→6C mode: The output relay of the charger becomes ON.

(⑤ LED ON ⑦ AC output through charging output connector ⑧ CP analysis display +6v, -12v waveform and CP analysis result display)

5. Press the charger knob switch and ④ PP_CHECK LED will blink from green to yellow.

6. If you change the state conversion switch to 6C→9B, the output relay of the charger turns OFF.

(⑤ LED OFF ⑦ Stop AC output from charging output connector ⑧ CP analysis display voltage +9V, -12V waveform output)

7. When the status conversion switch 9B→12A is changed, the charger displays charging completion (stop).


* When CP_SHORT ON or DIODE_SHORT is ON in charging standby (9B) or charging (6C) state, the charger must operate in error or turn off the charging relay.

* The internal battery of the tester must be charged in the charging (6C) mode.

Contact Us

For your inquiries, please contact us using the contact information below.

ADDRESS

806-ho, 32, Gyeongin-ro 53-gil, Guro-gu, Seoul, Republic of Korea (08215)

EMAIL

0000@evtester.co.kr

PHONE NUMBER

+82 010-2748-2251